[General] Problem in using mpiexec to run paraview on the Window 7?

Sia · October 30, 2013, 03:20

hi, my English is not good, but i will try my best to describe my question.
Here is the problem:
I'm using ParaView4.0.1 - 32bit on windows 7.
I used the command "mpiexec.exe -np 2 -host localhost pvserver.exe", two pvserver processes was started and worked fine.
But if I want to start 4 pvserver processes , 2 on computer1 and 2 on computer2, what command should I use?

wyldckat · November 1, 2013, 18:23

Greetings Sia and welcome to the forum!

I see that you've read this post: http://www.cfd-online.com/Forums/par...tml#post457840 - post #4

Since ParaView 4.0.1 on Windows uses Open-MPI, therefore these instructions should work: http://www.open-mpi.org/faq/?categor...imple-spmd-run

Best regards,
Bruno

October 30, 2013, 03:20	Problem in using mpiexec to run paraview on the Window 7?	#1
Sia New Member YaGao Join Date: Oct 2013 Posts: 1 Rep Power: 0	hi, my English is not good, but i will try my best to describe my question. Here is the problem: I'm using ParaView4.0.1 - 32bit on windows 7. I used the command "mpiexec.exe -np 2 -host localhost pvserver.exe", two pvserver processes was started and worked fine. But if I want to start 4 pvserver processes , 2 on computer1 and 2 on computer2, what command should I use? Last edited by Sia; October 30, 2013 at 04:31. Reason: typed wrong

November 1, 2013, 18:23		#2
wyldckat Retired Super Moderator Bruno Santos Join Date: Mar 2009 Location: Lisbon, Portugal Posts: 10,975 Blog Entries: 45 Rep Power: 128	Greetings Sia and welcome to the forum! I see that you've read this post: http://www.cfd-online.com/Forums/par...tml#post457840 - post #4 Since ParaView 4.0.1 on Windows uses Open-MPI, therefore these instructions should work: http://www.open-mpi.org/faq/?categor...imple-spmd-run Best regards, Bruno __________________ OpenFOAM: FAQ \| Getting started Forum: How to get help, to post code/output and forum guide Read this before sending me PM

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM] Problem on multicore in running paraview	foamF	ParaView	5	April 23, 2019 15:57
[General] PBS script to run ParaView in parallel on remote server	hconel	ParaView	0	December 25, 2018 02:38
problem during mpi in server: expected Scalar, found on line 0 the word 'nan'	muth	OpenFOAM Running, Solving & CFD	3	August 27, 2018 04:18
[OpenFOAM.org] ParaView intsllation problem	Srinivasa Rao	OpenFOAM Installation	6	August 25, 2015 06:27
window management problem.	chidu	CFX	0	March 7, 2005 11:00