CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ParaView (
-   -   Meridional View in Paraview (

shreyasr December 17, 2013 00:44

Meridional View in Paraview
Hi !
I'm exploring ParaView as an alternate to ANSYS CFD Post, and the application is related to post processing centrifigal pump simulations (steady).

Questions :
1. I'd like to know if any of you have used ParaView in post processing results from a centrifugal pump CFD analysis ?

2. Is anybody aware of a method to extract the meridional view/section and apply contours/vectors etc to it ? If not - any generic advice would be appreciated !

Thanks in advance!

wyldckat December 25, 2013 11:55

Hi Shreyas,

Meridional view... do you mean you want to use a cylindrical section-cut?
If this is the case, follow the instructions on this post: post #2

Best regards,

All times are GMT -4. The time now is 07:42.