|
[Sponsors] |
October 2, 2014, 12:17 |
how to hide air phase in paraview?
|
#1 |
Member
Yage
Join Date: May 2014
Posts: 60
Rep Power: 11 |
Dear Foamers,
How can I achieve to hide the air phase in paraview? i am using two-phase interdymfoam and I would like to see only object and water phase in a water tank in paraview. Regards, Yage |
|
October 3, 2014, 07:48 |
|
#2 |
Senior Member
|
Hi Yage,
You can use the clip filter and than clip by scalar, select alpha.water and set it at your desired volume fraction (0.5 usually works fine). Regards, Tom |
|
October 6, 2014, 04:37 |
|
#3 |
Member
Yage
Join Date: May 2014
Posts: 60
Rep Power: 11 |
Hi Tom,
Thanks for your reply and I would like to see view it like the one below: http://www.cfd-online.com/Forums/ope...tml#post381224 Regards, Yage |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem with two phase flow (air injected in water) | miles_davis | OpenFOAM | 15 | March 31, 2021 09:36 |
interFoam two-phase pipe flow air phase behaviour | katete | OpenFOAM Running, Solving & CFD | 11 | February 3, 2021 03:14 |
Need help to Simulate Phase change of Water liquid after mixing with Hot Air Stream | diineshns | FLUENT | 0 | March 17, 2018 06:14 |
Problem of simulating of small droplet with radius of 2mm | liguifan | OpenFOAM Running, Solving & CFD | 5 | June 3, 2014 02:53 |
[OpenFOAM] Paraview different phase with different color | liguifan | ParaView | 1 | March 15, 2013 01:34 |