[OpenFOAM] Cp plot on foil along section

nico765 · February 5, 2008, 07:02

Hello,

How can I do that?
Typical aerofoil section in 3D; i d like to extract pressure along a section and plot it.

Anything better than having to export to ensight?

Thanks,

Nicolas

sek · April 18, 2008, 20:01

I also need to plot pressure along an airfoil surface. What I tried are:

- Use "cut" utility under "Filter" submenu to extract he intersection of the foil and z = 0 plane
- Use "Append datasets" (I'm not sure whether I need this step)
- Then , use "Probe" to plot the surface quantities I want.

When I did all this, the x-y plot shows zero pressure. What did I do wrong? What does the x-aixs rerepsent? I want to make it x-coordinate of the point on the curve.

wolle1982 · December 18, 2008, 04:09

plot over a line is very simple in paraFoam.

ploting pressure along airfoil surface is best done with the "sample"-Tool.

go look at
http://www.cfd-online.com/OpenFOAM_D...s/1/10206.html

February 5, 2008, 07:02	Cp plot on foil along section	#1
nico765 Member nicolas Join Date: Mar 2009 Location: Glasgow Posts: 42 Rep Power: 17	Hello, How can I do that? Typical aerofoil section in 3D; i d like to extract pressure along a section and plot it. Anything better than having to export to ensight? Thanks, Nicolas

April 18, 2008, 20:01	I also need to plot pressure a	#2
sek Member Sung-Eun Kim Join Date: Mar 2009 Posts: 76 Rep Power: 17	I also need to plot pressure along an airfoil surface. What I tried are: - Use "cut" utility under "Filter" submenu to extract he intersection of the foil and z = 0 plane - Use "Append datasets" (I'm not sure whether I need this step) - Then , use "Probe" to plot the surface quantities I want. When I did all this, the x-y plot shows zero pressure. What did I do wrong? What does the x-aixs rerepsent? I want to make it x-coordinate of the point on the curve.

December 18, 2008, 04:09	plot over a line is very simpl	#3
wolle1982 Senior Member Wolfgang Heydlauff Join Date: Mar 2009 Location: Germany Posts: 136 Rep Power: 21	plot over a line is very simple in paraFoam. ploting pressure along airfoil surface is best done with the "sample"-Tool. go look at http://www.cfd-online.com/OpenFOAM_D...s/1/10206.html

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Contribute a forceCoeff plot and merge utility	lakeat	OpenFOAM Running, Solving & CFD	5	October 5, 2018 22:48
[Commercial meshers] converting Fluent mesh to openfoam standard mesh	deepesh	OpenFOAM Meshing & Mesh Conversion	31	March 29, 2017 05:59
How to plot pressure coefficent distribution arround a section of the wind blade?	mrswordf1sh	FLUENT	3	February 18, 2016 10:22
section discharge vs time	saravenu	CFX	1	January 15, 2016 05:45
Problem with plot of vapor volume fraction for each time step at a specific section	Walderdbeere	Fluent Multiphase	0	April 25, 2015 14:36