[General] Post-Process Layout

MrChips · July 31, 2016, 22:37

Is there any 'bring to front" or "send to back" feature in Paraview that would help me with my layout?

I have attached two photos:

The first shows a velocity map on the left and temperature on the right. The geometry I loaded in renders in front of the velocity map.
The second shows a velocity map on the left again, but the temperature map turned off. Again, the geometry I loaded in renders in front of the velocity map on the left and is shown hidden behind where the temperature map was.

Photo 1: https://drive.google.com/open?id=0Bz...nBPLWU3ZmNpblU
Photo 2: https://drive.google.com/file/d/0Bzm...ew?usp=sharing

Is there anyway to get the geometry to render "in front" in both cases?

Thanks,
Clayton

louisgag · October 20, 2020, 04:58

this is an old post, but in case someone wants a solution, ParaView is 3D, so you can translate the slice you want towards above/below using the transforming section of the properties panel

July 31, 2016, 22:37	Post-Process Layout	#1
MrChips New Member Clayton Join Date: Jul 2016 Posts: 2 Rep Power: 0	Is there any 'bring to front" or "send to back" feature in Paraview that would help me with my layout? I have attached two photos: The first shows a velocity map on the left and temperature on the right. The geometry I loaded in renders in front of the velocity map. The second shows a velocity map on the left again, but the temperature map turned off. Again, the geometry I loaded in renders in front of the velocity map on the left and is shown hidden behind where the temperature map was. Photo 1: https://drive.google.com/open?id=0Bz...nBPLWU3ZmNpblU Photo 2: https://drive.google.com/file/d/0Bzm...ew?usp=sharing Is there anyway to get the geometry to render "in front" in both cases? Thanks, Clayton Last edited by MrChips; August 1, 2016 at 10:53. Reason: Making the question more clear; links for photos

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Post processing journal - like .cst in CFD Post	Jiricbeng	FLUENT	0	April 24, 2019 08:08
Error running openfoam in parallel	fede32	OpenFOAM Programming & Development	5	October 4, 2018 16:38
Post process Eulerian multiphase model	hamed.majeed	FLUENT	0	August 31, 2018 13:47
error 262144 and unexpected disconnect when run on 2 nodes	Emily1412	SU2 Installation	1	April 10, 2014 17:08
Parallel process & CFD POST	jypark	FLUENT	2	August 14, 2013 23:49

October 20, 2020, 04:58		#2
louisgag Senior Member Louis Gagnon Join Date: Mar 2009 Location: Stuttgart, Germany Posts: 338 Rep Power: 18	this is an old post, but in case someone wants a solution, ParaView is 3D, so you can translate the slice you want towards above/below using the transforming section of the properties panel