[General] Cp plot at different stations on a wing

gfoam · May 31, 2012, 16:52

Hello:
I'm doing simulations with OF of a 3D wing and comparing the results of force coefficients an pressure coefficients distributions on the surface of the wing. To do the last thing I'm using the sample comand of OF and postprocessing the data with a spreadsheet, but the problem with that is I change the mesh the template done for that doesn't serve anymore. So, the question is: is there any way I can get the pressure distribution in the resulting curve to intercept a plane with the wing at different stations of the same, as I can do it with CFD Post of ANSYS? Thanks in advance.
Gonzalo

PD: Sorry for my bad English

taxalian · June 3, 2012, 07:55

Hi Gonzalo,
Well if you have the Cp as variable in your solution file. You can just do several spanwise slices/cuts in Paraview and do xy plot of these curves.

Hope this helps.

taxalian.

gfoam · June 3, 2012, 12:17

Well, I can do it with the filter PlotOnIntersectionCurves, with the patch "wing" highlighted only in the tree browser of paraview. Then with the chart done, I export the data generated with the function "save data" (file=>save data). This produces a file with the extension CSV that you can open with a spreadsheet.

May 31, 2012, 16:52	Cp plot at different stations on a wing	#1
gfoam Senior Member Gonzalo Join Date: Mar 2011 Location: Argentina Posts: 122 Rep Power: 16	Hello: I'm doing simulations with OF of a 3D wing and comparing the results of force coefficients an pressure coefficients distributions on the surface of the wing. To do the last thing I'm using the sample comand of OF and postprocessing the data with a spreadsheet, but the problem with that is I change the mesh the template done for that doesn't serve anymore. So, the question is: is there any way I can get the pressure distribution in the resulting curve to intercept a plane with the wing at different stations of the same, as I can do it with CFD Post of ANSYS? Thanks in advance. Gonzalo PD: Sorry for my bad English

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ffd_control_point_2d	feiyi	SU2	4	September 30, 2019 12:42
[swak4Foam] Foam warnings - related to swak4Foam	Salam-H	OpenFOAM Community Contributions	20	August 2, 2015 15:40
plot pressure distribution on a section of 3D wing	ROOZBEH	FLUENT	3	April 21, 2008 03:30
Pressure plot by wing slice	Matt	FLUENT	1	November 26, 2005 20:04
How to plot Cp of 3D wing section	Wason	FLUENT	3	July 11, 2000 17:44

June 3, 2012, 07:55		#2
taxalian Senior Member Join Date: Nov 2010 Posts: 139 Rep Power: 15	Hi Gonzalo, Well if you have the Cp as variable in your solution file. You can just do several spanwise slices/cuts in Paraview and do xy plot of these curves. Hope this helps. taxalian.

June 3, 2012, 12:17		#3
gfoam Senior Member Gonzalo Join Date: Mar 2011 Location: Argentina Posts: 122 Rep Power: 16	Well, I can do it with the filter PlotOnIntersectionCurves, with the patch "wing" highlighted only in the tree browser of paraview. Then with the chart done, I export the data generated with the function "save data" (file=>save data). This produces a file with the extension CSV that you can open with a spreadsheet.