|
[Sponsors] |
January 16, 2004, 10:40 |
Geometry error to debug
|
#1 |
Guest
Posts: n/a
|
Hi, i am desperately debugging on this, hope there is someone could advise.
After running the satellite, I have an error message like this "No line link to point PA and PAB1", also "No line link to point PAB2 and PB". My geometry command in Q1 file is like this: GSET(V, CV01, PA, PAB1, PAB2, PB) GSET(L, L01, PA, PB, 1, 1.0, CRV, CV01) GSET(F, F01, PA, PAB1.PAB2, PB,-, PC,-, PD,-) For your information, all variables are declared and assigned values, all points are defined. PA and and PB are the start point and ending point of the curve named cv01 respectively. PAB1 and PAB2 are intermediate points on this curve. Thank you for your time. |
|
January 16, 2004, 11:23 |
Re: Geometry error to debug
|
#2 |
Guest
Posts: n/a
|
FYI, those command are in different lines.
|
|
January 18, 2004, 02:17 |
Re: Geometry error to debug
|
#3 |
Guest
Posts: n/a
|
Jas,
As far as I recall, defining the curve CV01 as GSET(V, CV01, PA, PAB1, PAB2, PB) and the line L01 on it GSET(L, L01, PA, PB, 1, 1.0, CRV, CV01) only uses the intermediate points, PAB1, PAB2, but there is no line connecting PA to PAB1 and PAB2 to PB. Rather, there is a line connecting Pa to PB, passing through PAB1 and PAB2. This is what Satellite is complaining about. You should therefore merely change the frame definition from your current one, i.e., GSET(F, F01, PA, PAB1.PAB2, PB,-, PC,-, PD,-) to GSET(F, F01, PA, - , PB,-, PC,-, PD,-) I hope this would remove the difficulty. |
|
January 19, 2004, 07:22 |
Re: Geometry error to debug
|
#4 |
Guest
Posts: n/a
|
Thank you, it is solved.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
About "debug=T" | sammi | Phoenics | 0 | June 14, 2008 07:18 |
Debug switch | pierre | OpenFOAM Running, Solving & CFD | 5 | July 5, 2007 19:38 |
Problematic geometry error | Jenny | FLUENT | 4 | March 7, 2007 19:54 |
Debug of UDF in FLUENT | summer | FLUENT | 1 | August 29, 2006 17:54 |
Geometry Error Generation | Joe | CFX | 4 | March 15, 2005 22:57 |