CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Phoenics (
-   -   contaminant concentration in inlet (

Juan January 18, 2006 12:36

contaminant concentration in inlet
In my case, the inlet is not very far from the outlet. Therefore, some contaminant comes into domain through inlet again. I simulate the concentration of outlet for each time step, how could I add this value for each time step to inlet? Thank you very much for any suggestions.

Mick February 10, 2006 14:41

Re: contaminant concentration in inlet
1/ Store the values at each time step into a spare variable 2/ Set these stored values as those entering the domain through the inlet.

Note ground coding required for this, but it is not too difficult to do.

All times are GMT -4. The time now is 04:59.