|
[Sponsors] |
October 11, 2006, 18:04 |
Residuals values
|
#1 |
Guest
Posts: n/a
|
I am having some troubles in reading correctly the residuals values of the simulations. I have read in some articles that the convergence of a given simulation is obtained when the normalized residuals are smaller than E-03.
Where can I read these values from my simulations? Thanks. |
|
October 31, 2006, 05:27 |
Re: Residuals values
|
#2 |
Guest
Posts: n/a
|
For a 2D single-phase flow, near the bottom of the RESULT file you will find the following normalised residuals printout for the last sweep:
Whole-field residuals before solution with resref values determined by EARTH & resfac= 1.000E-03 variable resref (res sum)/resref P1 3.718E-09 1.562E+00 V1 7.078E-11 1.819E+02 W1 1.880E-08 6.684E-01 H1 8.555E-03 4.698E-01 MIXF 1.317E-10 5.908E-01 |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Residuals | Rakib | FLUENT | 26 | February 19, 2018 18:03 |
Ensight - node values -cell values | leo | FLUENT | 1 | May 12, 2010 08:47 |
Residuals | maka | OpenFOAM Bugs | 0 | August 4, 2008 14:07 |
Residuals again | Elbornin | FLUENT | 0 | January 26, 2007 14:00 |
node values or cell values? | aPpA | FLUENT | 0 | November 10, 2006 08:56 |