|
[Sponsors] |
October 17, 2006, 13:30 |
using Tecplot interface
|
#1 |
Guest
Posts: n/a
|
Hello,
I am trying to figure out how to use Tecplot interface of Phoenics. I simulated gas concentration decay with time during forced ventilation. I want to use Tecplot to plot the concentration contour for each time step. The structural grid was used. I will really appreciate if you would like to share your ideas on using this function with me. J.Z |
|
November 22, 2006, 23:53 |
TECPLOT interface in PHOENICS
|
#2 |
Guest
Posts: n/a
|
I do have the same problem. I have PHOENICS 3.6.1 and it just isnt doing anything when i try to export in tecplot.
|
|
November 26, 2006, 14:57 |
Re: using Tecplot interface
|
#3 |
Guest
Posts: n/a
|
Why dont you use the tecexe?. If it doesnt work, you have to change the array size of the translator. In the file tecmain.for, you can change the size and then run the bldtec file. That will bring out a new tecexe translator and it wont crash. If you are using windows, i suggest you to run the tecexe from a dos shell, and copy the phi file you want to translate to the same folder.
|
|
April 25, 2007, 16:31 |
Re: using Tecplot interface
|
#4 |
Guest
Posts: n/a
|
I want to use tecplot for a transient analysis, how do I read many phi files (a10,a20,....) to make an animation?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to read tecplot file witout tecplot ? | Pol | Tecplot | 11 | March 2, 2007 06:26 |