CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   Phoenics (http://www.cfd-online.com/Forums/phoenics/)
-   -   Display problem with PHOENICS 2006 (http://www.cfd-online.com/Forums/phoenics/52111-display-problem-phoenics-2006-a.html)

David October 18, 2006 11:05

Display problem with PHOENICS 2006
 
I installed 2006 version (3.6.2) on my notebook computer. Everything is working except there is a display problem. In Viwer or Editor, I can not zoom further than certain ratio. The diplayed object simply disappears from the window and it shows up again after zoom out. There was no such problem with previous version. Does anyone has same problem with this new version or is there any solution to it? Thank you in advance.

Wellington M. Brondani October 18, 2006 12:18

Re: Display problem with PHOENICS 2006
 
Hi David. I had the same problem. Go to the "Settings" tab and choose "Near Plane". Then set the value of "Near Plane" as minimum as possible. I hope that this tip solve your problem.

David October 19, 2006 07:27

Re: Display problem with PHOENICS 2006
 
Thank you Wellington. It worked.


All times are GMT -4. The time now is 23:43.