CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   Pointwise & Gridgen (http://www.cfd-online.com/Forums/pointwise/)
-   -   Extrude Normal Problem (http://www.cfd-online.com/Forums/pointwise/118631-extrude-normal-problem.html)

tomas89 May 31, 2013 05:46

Extrude Normal Problem
 
4 Attachment(s)
Dear all,

I'm new with pointwise and I'm doing the meshing of a foil and the mesh is growing inside and outside of the curve shown in the pic 1 and 2. Maybe this is because the growing arrows of the pic 3 didnt apear in my case.

Also how to face the problem with 2 foils like in the pic 4??

James_ May 31, 2013 11:36

Tomas,

You can try to find the answer to your problem in previous threads for instance:
http://www.cfd-online.com/Forums/poi...g-surface.html
http://www.cfd-online.com/Forums/poi...extrusion.html
http://www.cfd-online.com/Forums/poi...ayer-mesh.html

If the airfoil has the same cross section on both sides you can create 2D mesh and then use the path based extrusion.


All times are GMT -4. The time now is 12:51.