|
[Sponsors] |
June 14, 2014, 02:56 |
2D NACA0012 Block problem
|
#1 |
New Member
sk Kim
Join Date: Jun 2014
Posts: 1
Rep Power: 0 |
Hi
I am using the gridgen 15.08, and beginner. I generated meshes with 6 domains around NACA0012 airfoil. During the creating structured block, there is a error message as below. Block -> Create -> Assembles Faces -> Add 1st Face "The selected domain does not connect to the developing face in an appropriate manner. Try again." I can not selet only one domain please advise me. |
|
June 15, 2014, 11:31 |
|
#2 | |
Senior Member
Chris Sideroff
Join Date: Mar 2009
Location: Ottawa, ON, CAN
Posts: 434
Rep Power: 22 |
Quote:
Anyway, enough with the trip down memory lane. Basically, you can't make a single block with your domain topology. Make two blocks (e.g. 1 for top 3 domains and another for bottom 3). If you want a single block you'll have to go with a C or O topology. The 2D Airfoil tutorial in Gridgen is a C topology. |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Solution of problem through Matrx Block Method | Naseem Ahmad | Main CFD Forum | 0 | August 17, 2012 05:10 |
[ICEM] A challenging problem about "convert block type" | Xeder | ANSYS Meshing & Geometry | 0 | July 25, 2012 07:46 |
[Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 02:58 |
Stalling problem with simpleFoam on a NACA0012 | Damien | OpenFOAM Running, Solving & CFD | 1 | March 3, 2010 07:46 |
blockMesh: block with 6 vertexes | dani | OpenFOAM | 3 | June 25, 2009 13:13 |