Home > Forums > Mesh Generation & Pre-Processing Software > Pointwise & Gridgen

ACE+ pointwise

Mark Forums Read

Reply

Search this Thread

October 30, 2010, 11:30	ACE+ pointwise	#1
simulationman New Member Join Date: Oct 2010 Posts: 7 Rep Power: 15	Hi I have a complicated geometry created in Pro/E that I cannot import without distortion in CFD-GEOM. So I am planning to use another software to do that. Pointwise can import the drawings all right and can mesh it properly. The problem is.... can I import a mesh generated in pointwise to ACE+? I see some common formats.. but am not sure if they will work.

Reply

Tags

ace+, geom, pointwise, pro/e

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Native OpenFOAM interface in Pointwise	cnsidero	OpenFOAM Meshing & Mesh Conversion	41	May 20, 2012 18:30
Pointwise	Lodda	Pointwise & Gridgen	0	October 8, 2010 02:07
Pointwise	hm86	Pointwise & Gridgen	3	September 4, 2010 20:57
[Technical] Unspecified boundary types in the grids created employing Pointwise	arash	OpenFOAM Meshing & Mesh Conversion	5	February 9, 2010 09:56
Native OpenFOAM interface in Pointwise	Chris Sideroff	Main CFD Forum	0	January 16, 2009 12:37

All times are GMT -4. The time now is 10:30.