HOW to define ONE LINE the WALL boundary condition using pointwise V16 -- CFD Online Discussion Forums

October 27, 2010, 11:40

HOW to define ONE LINE the WALL boundary condition using pointwise V16

lachie

New Member

Xu Zhu

Join Date: Oct 2010

Posts: 12

Rep Power: 15

hello everyone:
Today i encounted a new problem: i have generated an unstructured grid around a parafoil, to be simpler, it is just a LINE. However, i found it is impossible to define the line the WALL boundary condition. i have tried many times but failed.
i use pointwise V16.02
help!

Attached Images

	question.jpg (47.3 KB, 6 views)
	question_grid.jpg (99.6 KB, 6 views)

Last edited by lachie; October 27, 2010 at 21:11.

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFOAM15 installables are incomplete problem with paraFoam	tryingof	OpenFOAM Bugs	17	December 7, 2008 04:41
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12
New topic on same subject - Flow around race car	Tudor Miron	CFX	15	April 2, 2004 06:18
Problems of Duns Codes!	Martin J	Main CFD Forum	8	August 14, 2003 23:19

All times are GMT -4. The time now is 07:45.