Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: Sniper

Forum: OpenFOAM Pre-Processing

December 6, 2013, 13:56

Replies: 3

Setting Boundary Conditions for stl geometry (periodic cooling fin tunnel)

Views: 1,875

Posted By Sniper

Hi, I actually meant channel395 it is under...

Hi,

I actually meant channel395 it is under tutorials/incompressible/pimple foam. You will find the cyclic boundary condition settings in that. If your mesh is not conformal then you may have to...

Forum: OpenFOAM Pre-Processing

December 4, 2013, 16:13

Replies: 3

Setting Boundary Conditions for stl geometry (periodic cooling fin tunnel)

Views: 1,875

Posted By Sniper

Hi Phil, I read your post in my...

Hi Phil,

I read your post in my thread on Simple open channel flow. I think it would be better if you go for the cyclicAMI boundary condition than mapped boundary. I think mapped...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 04:36.