Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Jonathan

Forum: OpenFOAM Running, Solving & CFD

February 3, 2014, 03:07

Replies: 7

BC's for k-omega SST (low / hi Re setups)

Views: 4,748

Posted By Jonathan

hi Kid, I havent looked at OF for a little...

hi Kid,

I havent looked at OF for a little while, but in the last version i was using (2.1.1), i finally used the following for a low Re mesh:

'k' -> set to SMALL no at wall
'omega' -> use...

Forum: OpenFOAM Running, Solving & CFD

October 4, 2012, 07:06

Replies: 7

BC's for k-omega SST (low / hi Re setups)

Views: 4,748

Posted By Jonathan

Hi Stephane, I didnt use a formula - looking...

Hi Stephane,

I didnt use a formula - looking through the forums and theory, i realise that omega tends to infinity at the wall - therefore, i just used a large number as the omega BC ...
...

Forum: OpenFOAM Running, Solving & CFD

September 26, 2012, 08:33

Replies: 7

BC's for k-omega SST (low / hi Re setups)

Views: 4,748

Posted By Jonathan

never mind ... solved it ...

never mind ... solved it ...

Forum: OpenFOAM Running, Solving & CFD

September 25, 2012, 18:22

Replies: 7

BC's for k-omega SST (low / hi Re setups)

Views: 4,748

Posted By Jonathan

BC's for k-omega SST (low / hi Re setups)

hi everyone,

i have been testing my k-omega SST setup for OF using a simple flat plate geometry, and BC's i have worked out from looking at a number of other posts on the issue. although there is...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 00:07.