Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: neilduffy1024

Forum: ANSYS Meshing & Geometry

May 28, 2010, 09:35

Replies: 8

[ICEM] Non Manifold Boundary

Views: 7,557

Posted By neilduffy1024

It didn't stop me from creating a mesh , however,...

It didn't stop me from creating a mesh , however, it was preventing me from creating an Ogrid which I required in order to properly capture the boundary layer. As I did not assign mesh parameters...

Forum: ANSYS Meshing & Geometry

May 27, 2010, 09:57

Replies: 8

[ICEM] Non Manifold Boundary

Views: 7,557

Posted By neilduffy1024

Unfortunately I spoke too soon regarding a...

Unfortunately I spoke too soon regarding a solution to the problem. I encountered the same error later on at a different section of the geometry and all vertices were on the same plane. The only...

Forum: ANSYS Meshing & Geometry

May 26, 2010, 05:58

Replies: 8

[ICEM] Non Manifold Boundary

Views: 7,557

Posted By neilduffy1024

Problem solved! My geometry has been extruded a...

Problem solved! My geometry has been extruded a very small amount (necessary to run a seemingly "2D" simulation in CFX). The problem arising from the non-manifold boundary was due to a vertice which...

Forum: ANSYS Meshing & Geometry

May 26, 2010, 05:30

Replies: 8

[ICEM] Non Manifold Boundary

Views: 7,557

Posted By neilduffy1024

Hi, I am having a similar problem to Ben. I have...

Hi, I am having a similar problem to Ben. I have created a block then mirrored the block about an axis which runs through one of the vertices. When I try to create an ogrid in either of these blocks...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 08:18.