Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: linnemann

Forum: OpenFOAM Meshing & Mesh Conversion

December 10, 2008, 05:59

Replies: 8

[snappyHexMesh] Mesh stl

Views: 1,523

Posted By linnemann

Just reread the post you made

Just reread the post you made and in order to get the internal mesh you have to place the point inside your geometry. If you place i outside snappyhexmesh will generate mesh outside your geometry.
...

Forum: OpenFOAM Meshing & Mesh Conversion

December 10, 2008, 05:55

Replies: 8

[snappyHexMesh] Mesh stl

Views: 1,523

Posted By linnemann

Hey Fab Unfortunately I don

Hey Fab

Unfortunately I don't have time right now to look into your case.

I haven't used snappyhexmesh with both internal and external mesh at the same time only one of them, so I don't...

Forum: OpenFOAM Meshing & Mesh Conversion

December 10, 2008, 02:30

Replies: 8

[snappyHexMesh] Mesh stl

Views: 1,523

Posted By linnemann

Hey Fab I can try. :-) I

Hey Fab

I can try. :-)

In order to have the pressure on a face you need to have that face as a separate patch on which you can do the pressure calculations.

To have a separate patch...

Forum: OpenFOAM Meshing & Mesh Conversion

December 9, 2008, 02:30

Replies: 8

[snappyHexMesh] Mesh stl

Views: 1,523

Posted By linnemann

Hey Fab Yes thats the whole

Hey Fab

Yes thats the whole idea with snappyhexmesh.

It's actually not intended as a 2d mesh tool as far as I know. The userguide example is only in 2d for easier understanding. If you look...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 16:07.