Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: biro

Forum: ANSYS Meshing & Geometry

August 19, 2014, 17:17

Replies: 7

[ICEM] Hexa-Meshing of sharp edge

Views: 1,645

Posted By biro

Ok, thank you. I will look for it tomorrow

Ok, thank you. I will look for it tomorrow

Forum: ANSYS Meshing & Geometry

August 19, 2014, 16:56

Replies: 7

[ICEM] Hexa-Meshing of sharp edge

Views: 1,645

Posted By biro

Today I have tried to start a job without the...

Today I have tried to start a job without the pipe and the bad regions (I deleted the section and started it in CFX) and the job is running. When I will start the job with the pipe and the bad...

Forum: ANSYS Meshing & Geometry

August 19, 2014, 05:38

Replies: 7

[ICEM] Hexa-Meshing of sharp edge

Views: 1,645

Posted By biro

For better understanding, I have added some...

For better understanding, I have added some screenshots of my inlet.
On the second picture the visibility of the front surface (of the box) is turned of, so you can the inside the pipe.
There is a...

Forum: ANSYS Meshing & Geometry

August 8, 2014, 16:48

Replies: 7

[ICEM] Hexa-Meshing of sharp edge

Views: 1,645

Posted By biro

Thanks for your answer. Unfortunately, I can't...

Thanks for your answer.
Unfortunately, I can't access my ICEM Modell this evening.
The blocking must be chosen based on the geometry. At Monday I will show some Screenshots for better...

Forum: ANSYS Meshing & Geometry

August 6, 2014, 18:02

Replies: 7

[ICEM] Hexa-Meshing of sharp edge

Views: 1,645

Posted By biro

Hexa-Meshing of sharp edge

Hello together,

for my thesis i have to work with icem cfd and cfx.
Therefore i'm a beginner in using both programms.

I've finished the blocking in icem (after a while) and refined the mesh...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 06:34.