Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Catthan

Forum: ANSYS Meshing & Geometry

November 17, 2010, 21:51

Replies: 6

ICEM Tetra mesh, Size reduction and Skewness problem

Views: 9,876

Posted By Catthan

Small progress & some visual

By messing with the part sizes I managed to improve my octree mesh, create prisms and even some nice hex elements.

Fluent however liked my TGrid mesh better so I am sticking with it for the...

Forum: ANSYS Meshing & Geometry

November 16, 2010, 08:40

Replies: 6

ICEM Tetra mesh, Size reduction and Skewness problem

Views: 9,876

Posted By Catthan

Hi again Simon. I have been playing with...

Hi again Simon.

I have been playing with flood fill and strangely the flood fill function set up in TGrid reports an error but if i run it from edit mesh it works fine and makes the material...

Forum: ANSYS Meshing & Geometry

November 14, 2010, 13:11

Replies: 6

ICEM Tetra mesh, Size reduction and Skewness problem

Views: 9,876

Posted By Catthan

Hi Simon, thaks for your reply. Mesh...

Hi Simon,
thaks for your reply.

Mesh extusion is a bright idea but i couldn't get it to work.
I have, say, a conical wall imersed in fluid so there is surface mesh in both sides of that wall. I...

Forum: ANSYS Meshing & Geometry

November 9, 2010, 10:45

Replies: 6

ICEM Tetra mesh, Size reduction and Skewness problem

Views: 9,876

Posted By Catthan

ICEM Tetra mesh, Size reduction and Skewness problem

Dear all,

I am using ICEM to mesh the combustion chamber of a Stirling engine MCHP.
What I am looking for is mainly heat transfer through walls.
Unfortunatelly I cannot show the geometry due...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 08:35.