Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: wyldckat

Forum: OpenFOAM Meshing & Mesh Conversion

September 7, 2013, 14:53

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By wyldckat

Hi JC, Unfortunately something strange is...

Hi JC,

Unfortunately something strange is going on with this mesh.
Attached is what should work, but doesn't.

I suggest that you step back a few steps and start by trying to mesh without the...

Forum: OpenFOAM Meshing & Mesh Conversion

September 1, 2013, 13:26

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By wyldckat

Hi JC, OK, not much time for seeing your...

Hi JC,

OK, not much time for seeing your case, so here are two examples:

Creating cyclic patches with createPatch:...

Forum: OpenFOAM Meshing & Mesh Conversion

September 1, 2013, 06:17

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By wyldckat

Hi JC, The problem with creating the sets...

Hi JC,

The problem with creating the sets before using snappyHexMesh is that the locations of the face indexes will be completely lost, as shown in the attached image.
I used:
reconstructParMesh...

Forum: OpenFOAM Meshing & Mesh Conversion

August 31, 2013, 08:32

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By wyldckat

Hi JC, If you run this command: ...

Hi JC,

If you run this command:
createPatch -helpyou'll see that you can also run createPatch in parallel, which means that you can run it before reconstructParMesh ;)

Best regards,
Bruno

Forum: OpenFOAM Meshing & Mesh Conversion

August 16, 2013, 07:02

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By wyldckat

Hi JC, I've moved these posts of yours to a...

Hi JC,

I've moved these posts of yours to a single thread, to make it easier to answer and to keep the discussion in a single thread ;)

Have a look into this thread:...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 11:28.