Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Touré

Forum: ANSYS Meshing & Geometry

August 5, 2012, 17:07

Replies: 6

[ICEM] Using Blocking with ICEM (infinity lines appear)

Views: 3,020

Posted By Touré

Solved

It was the tolerance which were too big. I reduced the tolerances in Menu -> Settings -> Model

Forum: ANSYS Meshing & Geometry

October 13, 2011, 13:06

Replies: 6

[ICEM] Using Blocking with ICEM (infinity lines appear)

Views: 3,020

Posted By Touré

No. I did not blank the "VORFN" part just to show...

No. I did not blank the "VORFN" part just to show that I am missing a vetical line on the right side of my domain and the blocking is not closed on the right and the left sides (See the third picture...

Forum: ANSYS Meshing & Geometry

October 12, 2011, 23:09

Replies: 6

[ICEM] Using Blocking with ICEM (infinity lines appear)

Views: 3,020

Posted By Touré

I have tried to reset the settings and marked ...

I have tried to reset the settings and marked Initialize with settings also in the Block menu. I am using 2D planar. So, I can not choose entities.

Forum: ANSYS Meshing & Geometry

October 11, 2011, 21:44

Replies: 6

[ICEM] Using Blocking with ICEM (infinity lines appear)

Views: 3,020

Posted By Touré

Using Blocking with ICEM (infinity lines appear)

Hello,
I am trying to mesh with ICEM a domain of a flow over a backward facing step but it doesn't work using Blocking. When I use Blocking my 2D domain is not closed. The upper and lower blocking...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 02:05.