Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: johnp

Forum: ANSYS Meshing & Geometry

August 10, 2010, 17:45

Replies: 14

[ICEM] beginner questions for ICEM CFD

Views: 4,602

Posted By johnp

Neewbie, thanks for your input. i was able...

Neewbie,

thanks for your input. i was able to import the mesh by removing the periodic faces and vertices in ICEM and remeshing. i then set up the periodic BC's in Fluent. Solver is still running,...

Forum: ANSYS Meshing & Geometry

August 10, 2010, 11:07

Replies: 14

[ICEM] beginner questions for ICEM CFD

Views: 4,602

Posted By johnp

Neewbie, you bring up an interesting point...

Neewbie,

you bring up an interesting point that was i thinking of addressing in a separate post. When there are only 2 nodes (1 cell) in the flow direction, i receive an error when importing the...

Forum: ANSYS Meshing & Geometry

August 10, 2010, 10:30

Replies: 14

[ICEM] beginner questions for ICEM CFD

Views: 4,602

Posted By johnp

Simon, i did the opposite and matched the...

Simon,

i did the opposite and matched the inner to the outer. Thanks for the tips on the bigeometric. i'm slowly getting the hang of this...

Neewbie,

it is a 3D geometry, however the length...

Forum: ANSYS Meshing & Geometry

August 9, 2010, 21:40

Replies: 14

[ICEM] beginner questions for ICEM CFD

Views: 4,602

Posted By johnp

Simon, Thanks for the detailed explanation....

Simon,

Thanks for the detailed explanation. i was able to follow your steps and produce what i believe is a reasonable mesh. Going through the process generated some additional questions:

1....

Forum: ANSYS Meshing & Geometry

August 5, 2010, 22:17

Replies: 14

[ICEM] beginner questions for ICEM CFD

Views: 4,602

Posted By johnp

Simon, Thanks for the detailed response. i...

Simon,

Thanks for the detailed response. i was able to successfully split the blocks and generate the mesh. A view of the left bank is attached. i ran into two problems:

1. there are about 75...

Forum: ANSYS Meshing & Geometry

August 4, 2010, 14:47

Replies: 14

[ICEM] beginner questions for ICEM CFD

Views: 4,602

Posted By johnp

neewbie and Simon, Thank you for your...

neewbie and Simon,

Thank you for your responses. i will try blocking with Octree. When i tried blocking before, i was using the premesh parameters to generate quad elements on the inlet face. i'll...

Forum: ANSYS Meshing & Geometry

August 3, 2010, 22:16

Replies: 14

[ICEM] beginner questions for ICEM CFD

Views: 4,602

Posted By johnp

beginner questions for ICEM CFD

Hi everyone,
I’m fairly new to ICEM CFD and would like some advice. As background, I feel confident creating structured meshes with blocking and the pre-mesh parameters. However, I’m now looking...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 03:52.