Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: ghorrocks

Forum: CFX

June 1, 2011, 18:24

Replies: 7

specifying interface boundary condition

Views: 2,446

Posted By ghorrocks

In general yes, but I do not know specifically...

In general yes, but I do not know specifically what you are doing so cannot say for sure on your case.

Forum: CFX

May 31, 2011, 08:18

Replies: 7

specifying interface boundary condition

Views: 2,446

Posted By ghorrocks

That's why I say to freeze the volume fraction...

That's why I say to freeze the volume fraction equation and the run time will not be too much longer than a single phase model.

Forum: CFX

May 19, 2011, 18:48

Replies: 7

specifying interface boundary condition

Views: 2,446

Posted By ghorrocks

Set up a multiphase simulation with one fluid as...

Set up a multiphase simulation with one fluid as one phase and the other fluid as the other phase. Use a single domain. Set an initial conidtion on the volume fraction for the location of the two...

Forum: CFX

May 19, 2011, 07:44

Replies: 7

specifying interface boundary condition

Views: 2,446

Posted By ghorrocks

Is the x direction prependicular to the surface?...

Is the x direction prependicular to the surface? Then isn't this simply the shear stress on one side of the interface is the same as the other?

I cannot think of an easy way to implement this with...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 16:16.