CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Members List Search Today's Posts Mark Forums Read

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: anno_x
Forum: ANSYS Meshing & Geometry December 27, 2010, 12:14
Replies: 15
Views: 6,015
Posted By anno_x
I did every step Simon mentioned above! but the...

I did every step Simon mentioned above! but the problem was concerned about splitting the block. when I created the first 2D block, I associated it to box BCs. but I didn't know after splitting the...
Forum: ANSYS Meshing & Geometry December 27, 2010, 11:18
Replies: 15
Views: 6,015
Posted By anno_x
Thanks for the reply Simon, I checked the parts...

Thanks for the reply Simon, I checked the parts as you instructed. But I guess only closed shape parts eg. circles export to .msh format. Inlet is a line part, but
it can't be exported to fluent as...
Forum: ANSYS Meshing & Geometry December 27, 2010, 10:31
Replies: 15
Views: 6,015
Posted By anno_x
yes Santosh! As you mentioned, I used msh file...

yes Santosh! As you mentioned, I used msh file format, but when I open it in cfx, no boundary appears to select!

I wonder if you have any time to check the ICEM file as attached. I am really...
Forum: ANSYS Meshing & Geometry December 27, 2010, 02:52
Replies: 15
Views: 6,015
Posted By anno_x
I also extruded my mesh with 1 layer thickness...

I also extruded my mesh with 1 layer thickness and exported as cfx5 file. but still when I want to select a location for boundaries, non of my ICEM parts appears!
Forum: ANSYS Meshing & Geometry December 26, 2010, 16:19
Replies: 15
Views: 6,015
Posted By anno_x
thank you Santhosh.;) the problem is concerning...

thank you Santhosh.;) the problem is concerning cfx doesn't accept 2D mesh! I saved the file as fluent mesh.
and one other question about importing the mesh to Ansys WB;
in ansys WB, I opened...
Forum: ANSYS Meshing & Geometry December 26, 2010, 11:19
Replies: 15
Views: 6,015
Posted By anno_x
thank you for your quick help santhosh. after I...

thank you for your quick help santhosh. after I generated unstructured mesh as you mentioned in your post, then I clicked Write Input (in output tab) to save the mesh as cfx5 format,but the following...
Forum: ANSYS Meshing & Geometry December 26, 2010, 10:15
Replies: 15
Views: 6,015
Posted By anno_x
Hi, I have the same 2D geometry. I created the...

Hi, I have the same 2D geometry. I created the same pre mesh with edge params and curve mesh setup. now for the analysis in ANSYS WB I should generate mesh from this pre mesh. my first question is...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -4. The time now is 03:46.