Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: PSYMN

Forum: ANSYS Meshing & Geometry

July 29, 2009, 09:53

Replies: 7

[ICEM] Pipebranch hexa meshing

Views: 3,380

Posted By PSYMN

ic_hex_create_composite

This is the command for grouping curves...

I didn't do it explicitly, but probably selected one edge (or multiple edges) to associate to more than one curve. Before that can happen, the code...

Forum: ANSYS Meshing & Geometry

July 27, 2009, 17:43

Replies: 7

[ICEM] Pipebranch hexa meshing

Views: 3,380

Posted By PSYMN

Icem cfd...

Sorry, I don't have time for much of a write up, but I will post pics...

I didn't end up doing it the way I planned (no Boundary layer ogrid in the combustion chamber), but I think this should...

Forum: ANSYS Meshing & Geometry

July 24, 2009, 12:12

Replies: 7

[ICEM] Pipebranch hexa meshing

Views: 3,380

Posted By PSYMN

Bad associations...

I will try to block it between now and Monday (should be quicker than it takes to write up the explanation of what I did).

As for your current blocking, it should give you positive determinants...

Forum: ANSYS Meshing & Geometry

July 23, 2009, 08:57

Replies: 7

[ICEM] Pipebranch hexa meshing

Views: 3,380

Posted By PSYMN

T-Pipe

That is a T-pipe actually. They are easier than a Y pipe (no messy collapsing, etc.).

I could quickly block it for you (5 or 10 minutes) if you sent me your tetin file (you could send it...

Forum: ANSYS Meshing & Geometry

July 21, 2009, 17:01

Replies: 7

[ICEM] Pipebranch hexa meshing

Views: 3,380

Posted By PSYMN

All at once?

With ICEM CFD Hexa, we would usually ogrid it all at once. Select all the blocks and put faces on the inlets and outlets.

The best reason for doing it in stages is if you want the ogrids (and...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 16:28.