Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: PSYMN

Forum: ANSYS Meshing & Geometry

October 12, 2009, 14:56

Replies: 2

ICEM Prism Layer transition between surface with prism layers and one without

Views: 4,818

Posted By PSYMN

In case I didn't explain enough...

I just noticed I didn't explain the problem... If your boundary layer has very thin prisms along the wall, these will not cap well because the pyramids and tetras would have to be very high aspect...

Forum: ANSYS Meshing & Geometry

October 12, 2009, 14:54

Replies: 2

ICEM Prism Layer transition between surface with prism layers and one without

Views: 4,818

Posted By PSYMN

...Not very timely, but better late than never?

If you just stop the prism at the internal outflow boundary, the pyramids and tetras attached would likely be very poor quality. I recomend putting a much taller initial height in the slip area so...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 21:11.