Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: PSYMN

Forum: ANSYS Meshing & Geometry

August 7, 2012, 08:53

Replies: 21

[ICEM] ICEM problem

Views: 6,123

Posted By PSYMN

Can you access the customer portal or the student...

Can you access the customer portal or the student portal? These tutorials are updated each release. I don't know which one you mean specifically, but chances are that there is an updated version.

Forum: ANSYS Meshing & Geometry

March 12, 2010, 08:49

Replies: 21

[ICEM] ICEM problem

Views: 6,123

Posted By PSYMN

Maybe someone else knows?

That option was put in before I took over the product.

Most of these features are driven by customer demand... I have never needed to use that Zone ID because Fluent assigns it for me.

Perhaps...

Forum: ANSYS Meshing & Geometry

March 11, 2010, 17:00

Replies: 21

[ICEM] ICEM problem

Views: 6,123

Posted By PSYMN

Hands on help... Continued

Ok, above we sorted out the geometry prep and meshing. Now we look at setting Bocos. I Chose FLUENT as my solver and have expanded some branches of the tree.

2538

If I had volume...

Forum: ANSYS Meshing & Geometry

March 11, 2010, 16:57

Replies: 21

[ICEM] ICEM problem

Views: 6,123

Posted By PSYMN

Hands on help...

So the first thing I noticed was that you had no surfaces, just curves. It is possible to mesh like this, but then it becomes a hassle because you have to select the area (material) elements and put...

Forum: ANSYS Meshing & Geometry

March 9, 2010, 10:19

Replies: 21

[ICEM] ICEM problem

Views: 6,123

Posted By PSYMN

No problem...

You could try "Geometry Tab => Repair => Build Diagnostic Topology". This will create curves around all your surfaces... If you leave the "inherit part" checkbox (near the top above the other...

Forum: ANSYS Meshing & Geometry

March 8, 2010, 16:34

Replies: 21

[ICEM] ICEM problem

Views: 6,123

Posted By PSYMN

questions...

1) I guess you could do it in Fluent, but then you would be selecting elements, etc. I have never done it that way. It is much easier to setup the Geometry Parts in ICEM CFD.

2) You have one...

Forum: ANSYS Meshing & Geometry

March 8, 2010, 15:42

Replies: 21

[ICEM] ICEM problem

Views: 6,123

Posted By PSYMN

Boundary conditions are based on part names... If...

Boundary conditions are based on part names... If you know you will need different bocos for each curve, you must put each one in its own Part.

If this is a 2D model, Bocos should be applied to...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 23:55.