Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: PSYMN

Forum: ANSYS Meshing & Geometry

July 19, 2011, 10:00

Replies: 9

[ANSYS Meshing] Icem cfd - hexa meshing

Views: 4,040

Posted By PSYMN

As often happens...

As often happens, your first try at a particular topology (such as a torpedo) is not really your best. As soon as you look back on it, you can think of a better topology.

If I did this one again,...

Forum: ANSYS Meshing & Geometry

July 18, 2011, 21:57

Replies: 9

[ANSYS Meshing] Icem cfd - hexa meshing

Views: 4,040

Posted By PSYMN

Done...

For collapse blocks, you select the direction to collapse... This is the edge you want to go away... And then you select all the blocks you want to collapse in that direction.

I did if for you...

Forum: ANSYS Meshing & Geometry

July 18, 2011, 08:21

Replies: 9

[ANSYS Meshing] Icem cfd - hexa meshing

Views: 4,040

Posted By PSYMN

initial impressions...

Taking a closer look at your actual model, I see that your fins have sharp trailing edges. This means you need to collapse the blocks behind these edges... (under Merge Vertices, you can learn more...

Forum: ANSYS Meshing & Geometry

July 14, 2011, 14:07

Replies: 9

[ANSYS Meshing] Icem cfd - hexa meshing

Views: 4,040

Posted By PSYMN

Just click on the edge behind the torpedo and...

Just click on the edge behind the torpedo and match it to the edge at the back of the torpedo... You can even do this at the far field if you like... Once that aspect ratio is reduced, quality will...

Forum: ANSYS Meshing & Geometry

July 14, 2011, 12:12

Replies: 9

[ANSYS Meshing] Icem cfd - hexa meshing

Views: 4,040

Posted By PSYMN

Aspect ratio...

That mesh has poor aspect ratio...

The solution is with adjusting the edge parameters behind the torpedo... Ideally, you would match edges (edge distributions) behind the torpedo to match the...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 15:16.