Forum: FLUENT
January 21, 2013, 04:11
|
|
Replies: 23
Views: 5,600
|
|
Forum: FLUENT
January 19, 2013, 17:29
|
|
Replies: 23
Views: 5,600
this is my inlet profile: ...
this is my inlet profile:
DEFINE_PROFILE(solid_massflow, t, i)
{ cell_t c; face_t f; Thread *ct;
begin_c_loop(c, t)
{ ct = t->t0;
F_PROFILE(c,t,i) = C_UDMI(c,ct,0);}
end_c_loop(c,t)
}
|
|
Forum: FLUENT
January 19, 2013, 17:26
|
|
Replies: 23
Views: 5,600
|
|
Forum: FLUENT
January 19, 2013, 17:23
|
|
Replies: 23
Views: 5,600
thanks a lot!
with DEFINE_ADJUST,it seems...
thanks a lot!
with DEFINE_ADJUST,it seems working now but it gives inlet very small values comparison to outlet like(solid phase mass flow rate in inlet 1.3,outlet 227) but I don't understand...
|
|
Forum: FLUENT
January 18, 2013, 08:07
|
|
Replies: 23
Views: 5,600
|
|
Forum: FLUENT
January 18, 2013, 06:13
|
|
Replies: 23
Views: 5,600
|
|
Forum: FLUENT
January 18, 2013, 04:16
|
|
Replies: 23
Views: 5,600
|
|
Forum: FLUENT
January 16, 2013, 07:05
|
|
Replies: 23
Views: 5,600
thanks for quick answer!
I am simulating...
thanks for quick answer!
I am simulating gas-solid flow. So I want to save velocity and volume fraction in outlet and then to use it in inlet so I managed to save it with C_UDMI but in inlet...
|
|
Forum: FLUENT
January 16, 2013, 06:43
|
|
Replies: 23
Views: 5,600
to use outlet velocity in inlet
hi,
is ti possible to use this command in inlet where C_UDMI(c,t,2) is outlet velocity F_PROFILE(c,t,i) = C_UDMI(c,t,2);
thanks in advance!!!
|
