Forum: ANSYS Meshing & Geometry
October 28, 2011, 04:44
|
Replies: 33
Views: 5,400
Hi
I have never simulate cyclone so I can’t...
Hi
I have never simulate cyclone so I can’t tell is that kind of modification affect on simulation results but changes are small so probably impact will be negligible. However, you extruded inlet so...
|
Forum: ANSYS Meshing & Geometry
October 26, 2011, 08:56
|
Replies: 33
Views: 5,400
|
Forum: ANSYS Meshing & Geometry
October 26, 2011, 08:47
|
Replies: 33
Views: 5,400
|
Forum: ANSYS Meshing & Geometry
October 26, 2011, 07:27
|
Replies: 33
Views: 5,400
Hi,
I took a look at your project and you...
Hi,
I took a look at your project and you didn’t merge vertices marked in the picture. To do so you have to go to Blocking -> Merge Vertices-> Merge Vertices by Number or Tolerance, but as I wrote...
|
Forum: ANSYS Meshing & Geometry
October 26, 2011, 04:11
|
Replies: 33
Views: 5,400
|
Forum: ANSYS Meshing & Geometry
October 26, 2011, 01:46
|
Replies: 33
Views: 5,400
|
Forum: ANSYS Meshing & Geometry
October 25, 2011, 02:01
|
Replies: 33
Views: 5,400
Hi
Probably you didn’t include part with...
Hi
Probably you didn’t include part with contact surface to parts selected to meshing. This surface have to be mesh in both (hex and theta) grids. Also you have to create material point to generate...
|
Forum: ANSYS Meshing & Geometry
October 24, 2011, 03:15
|
Replies: 33
Views: 5,400
Hi,
First step is to build topology for your...
Hi,
First step is to build topology for your geometry. Then, create new part e.g. INTERFACE and put there contact surface, between 2 domains, only. Generate your meshes, load and merge them, then...
|
Forum: ANSYS Meshing & Geometry
October 21, 2011, 07:31
|
Replies: 33
Views: 5,400
|
Forum: ANSYS Meshing & Geometry
October 21, 2011, 07:01
|
Replies: 33
Views: 5,400
|
Forum: ANSYS Meshing & Geometry
October 21, 2011, 05:20
|
Replies: 33
Views: 5,400
Hi
In ICEM CFD you can merge mesh in few...
Hi
In ICEM CFD you can merge mesh in few different ways. You can generate grids separately, then load and merge both. In this way you will have non-conformal mesh. To connect nodes on contact...
|