Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: mariconeagles96

Forum: CFX

April 20, 2012, 10:02

Replies: 11

Mold Tube Cooling

Views: 1,937

Posted By mariconeagles96

Probably do the 1st one...so how to do it? Hw can...

Probably do the 1st one...so how to do it? Hw can i specify fixed temp on the surface of my moulded part? Coz i think in fluent, you can make your temp as a source. In cfx, shall i make use of the...

Forum: CFX

April 19, 2012, 12:09

Replies: 11

Mold Tube Cooling

Views: 1,937

Posted By mariconeagles96

plastic...temperature at 250C. So I intend to...

plastic...temperature at 250C. So I intend to make my temperature my source for I dont have any heat source in the moulded part. So by doing that, Im trying to check the gradient across my moulding...

Forum: CFX

April 18, 2012, 08:31

Replies: 11

Mold Tube Cooling

Views: 1,937

Posted By mariconeagles96

thanks ghorrocks! the objective of my simulation...

thanks ghorrocks! the objective of my simulation is to check the thermal gradient on the mould because we are planning to change the design of our cooling tubes. It can be steady state or at a...

Forum: CFX

April 17, 2012, 22:47

Replies: 11

Mold Tube Cooling

Views: 1,937

Posted By mariconeagles96

Mold Tube Cooling

Im trying to investigate the thermal cooling inside the mold. The tube is about 8mm in diameter and the mold block is about 100x50x20mm. I dont have the proper heat to be use as my heat source but...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 15:57.