Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: EtaEta

Forum: CFX

December 8, 2011, 16:57

Replies: 7

CFX13 Post Periodic interface

Views: 4,701

Posted By EtaEta

Yes, I did. CFX 11 run has same velocities at...

Yes, I did. CFX 11 run has same velocities at periodic boundary in CFX 13 Post. But still, the run from CFX 13, in CFX 13 Post, shows slightly different velocities. :(

(CFX 11 Post does not...

Forum: CFX

December 8, 2011, 16:46

Replies: 7

CFX13 Post Periodic interface

Views: 4,701

Posted By EtaEta

If you look to the picture, you can see there is...

If you look to the picture, you can see there is a clear shift in the middle.
Normally, two periodic interfaces should coincide and have same values.

It is a not a interface problem. I think...

Forum: CFX

December 8, 2011, 14:18

Replies: 7

CFX13 Post Periodic interface

Views: 4,701

Posted By EtaEta

Here are CCL & image

I attached an axial cut of passage. It shows an unexplainable shift.

Thank you

Here is the CCL:
+--------------------------------------------------------------------+
| ...

Forum: CFX

December 7, 2011, 18:13

Replies: 7

CFX13 Post Periodic interface

Views: 4,701

Posted By EtaEta

CFX13 Post Periodic interface

I am simulating a axial compressor rotor. I used my mesh in CFX11 and CFX 13. I waited until mass is converged for both cases.

When I used CFX 11, upper periodic side and lower periodic side have...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 02:11.