Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: rks171

Forum: STAR-CCM+

March 21, 2012, 09:47

Replies: 8

What to do about this warning?

Views: 4,581

Posted By rks171

Unfortunately, I don't think I'll have the time...

Unfortunately, I don't think I'll have the time to re-mesh and run again because if I'm going to get results from this case, I need to get them very soon, so I'll just see where this case goes. I...

Forum: STAR-CCM+

March 20, 2012, 11:43

Replies: 8

What to do about this warning?

Views: 4,581

Posted By rks171

I'm thinking about this problem a little more. ...

I'm thinking about this problem a little more. You said the problem is either min or max temps, but I didn't get any warnings about the temperature being limited by the min or max limits like I did...

Forum: STAR-CCM+

March 20, 2012, 11:31

Replies: 8

What to do about this warning?

Views: 4,581

Posted By rks171

So, you're saying that I want to get the prism...

So, you're saying that I want to get the prism layers thinner so that I can get them further into that crevice? My original thinking was that I should try and just get one big cell to take care of...

Forum: STAR-CCM+

March 20, 2012, 09:38

Replies: 8

What to do about this warning?

Views: 4,581

Posted By rks171

I took your advice. It is a max temp problem. I...

I took your advice. It is a max temp problem. I have temperatures up to 1500 K. I set a threshold of 700 K. The problem cells are all in a part of the geometry where two surfaces get very close...

Forum: STAR-CCM+

March 19, 2012, 16:29

Replies: 8

What to do about this warning?

Views: 4,581

Posted By rks171

What to do about this warning?

During my simulation, after every iteration, I get this warning:

Temperature corrections limited in 175 cells in region Body 1

The number of cells changes each time. It goes up and down. One...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 05:05.