Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: DonQuijote

Forum: Fidelity CFD

October 15, 2012, 03:23

Replies: 12

Problem with Secreening

Views: 2,711

Posted By DonQuijote

Problem solved. The problem, as other posts...

Problem solved.

The problem, as other posts says, is an installation problem, in my case regarding my windows 7 version. I solved the problem reinstalling the sotware in a windowsXP computer....

Forum: Fidelity CFD

October 2, 2012, 04:18

Replies: 12

Problem with Secreening

Views: 2,711

Posted By DonQuijote

Thank you for your advice. The two steps you...

Thank you for your advice.

The two steps you mention are ok, so here, unfortunately, is not the problem. In other way, I have tried to run a simulation in fine/turbo (made a new project without...

Forum: Fidelity CFD

October 1, 2012, 09:35

Replies: 12

Problem with Secreening

Views: 2,711

Posted By DonQuijote

I've tried it but the result is the same... I'm...

I've tried it but the result is the same...
I'm getting mad...

ok, I will explain my process for if I'm missing any step:

1-create my geometry and export in .geomturbo file extension
2- Open...

Forum: Fidelity CFD

October 1, 2012, 07:21

Replies: 12

Problem with Secreening

Views: 2,711

Posted By DonQuijote

Dear Hamid, I searched this file before and...

Dear Hamid,

I searched this file before and it wasn't in any folder. In the folder you mention only appears a computation1.run and job_euranus.

There is a similar problem in this post:...

Forum: Fidelity CFD

October 1, 2012, 04:29

Replies: 12

Problem with Secreening

Views: 2,711

Posted By DonQuijote

Dear Hamid, Thanks again for your reply....

Dear Hamid,

Thanks again for your reply. I've tried what you see, but when I open the monitor (with 'euranus started'), the monitor requests a .res (residual) file, which I don't have in any...

Forum: Fidelity CFD

October 1, 2012, 02:12

Replies: 12

Problem with Secreening

Views: 2,711

Posted By DonQuijote

Hi Hamid, Thank you for your reply. Yes, I...

Hi Hamid,
Thank you for your reply. Yes, I want to run an optimization process. So I wanted to follow the steps cited in this post:...

Forum: Fidelity CFD

September 28, 2012, 06:54

Replies: 12

Problem with Secreening

Views: 2,711

Posted By DonQuijote

Problem with Secreening

Hello,

I'm new in Numeca world and I hope somenone could help me
I have a problem launching Autoblade CFD-Screening. When I start the process (geometry made in autoblade, mesh ni AG5), the Fine...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 07:08.