Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: hjasak

Forum: OpenFOAM Running, Solving & CFD

May 10, 2006, 08:05

Replies: 7

Modeling in micron scale using icoFoam

Views: 4,397

Posted By hjasak

I would recommend you stick to

I would recommend you stick to double precision whenever possible - it eliminates a lot of potential problem sources. Unless you are planning to run hundred million cell runs and relatively simple...

Forum: OpenFOAM Running, Solving & CFD

May 10, 2006, 07:31

Replies: 7

Modeling in micron scale using icoFoam

Views: 4,397

Posted By hjasak

Hi, Good: progress! :-)

Hi,

Good: progress! :-)

a) In order to run single precision, you would need to re-compile the code yourself or download a single precision version. This is controlled by:

setenv...

Forum: OpenFOAM Running, Solving & CFD

May 10, 2006, 05:20

Replies: 7

Modeling in micron scale using icoFoam

Views: 4,397

Posted By hjasak

A few comments: - if you are

A few comments:
- if you are running an incompressible flow solver, the pressure level at the outlet is irrelevant and you can put it to zero rather than 1 bar. It should make no difference (only...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 17:18.