Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: Hiroshiman

Forum: OpenFOAM Meshing & Mesh Conversion

August 12, 2013, 09:23

Replies: 7

[snappyHexMesh] snappyhexmesh

Views: 2,602

Posted By Hiroshiman

sasanghomi : An few things : if you look at...

sasanghomi :
An few things : if you look at the STLSolidLabeling in paraview of your out.stl you'll see the separated surface, it worked fine.
Concerning the mesh generation, your blockMeshDict...

Forum: OpenFOAM Meshing & Mesh Conversion

August 10, 2013, 15:57

Replies: 7

[snappyHexMesh] snappyhexmesh

Views: 2,602

Posted By Hiroshiman

I mean in.stl is your original file and out.stl...

I mean in.stl is your original file and out.stl is the newly generated one. The angle is the angle which will be used to separate surface ; it's similar to the autoPatch function but on the stl, not...

Forum: OpenFOAM Meshing & Mesh Conversion

August 9, 2013, 07:59

Replies: 7

[snappyHexMesh] snappyhexmesh

Views: 2,602

Posted By Hiroshiman

You can spit your .stl by angle before meshing...

You can spit your .stl by angle before meshing using surfaceAutoPatch in.stl out.stl angle SnappyHexMesh will then consider the different patchs. It can be coupled with surfaceFeatureExtract a...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 16:06.