Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: gschaider

Forum: OpenFOAM Meshing & Mesh Conversion

June 7, 2006, 11:30

Replies: 29

[Commercial meshers] Converting meshes that includes interfaces

Views: 5,368

Posted By gschaider

Hi Marcus! First converter,

Hi Marcus!

First converter, then split mesh: Yep. SplitMesh needs an OpenFOAM-native mesh which only the converter can provide.

What was the error message of the converter?

Forum: OpenFOAM Meshing & Mesh Conversion

June 7, 2006, 10:36

Replies: 29

[Commercial meshers] Converting meshes that includes interfaces

Views: 5,368

Posted By gschaider

Hi Marcus! For OpenFOAM a f

Hi Marcus!

For OpenFOAM a faceSet is a set of faces ;) They have no special meaning and are used for "adminstrative" purposes

The fluentMeshToFoam-converter creates a faceSet for every...

Forum: OpenFOAM Meshing & Mesh Conversion

June 7, 2006, 10:26

Replies: 29

[Commercial meshers] Converting meshes that includes interfaces

Views: 5,368

Posted By gschaider

Hi Anne. Problem could be,

Hi Anne.

Problem could be, that when you use createMesh it takes the mesh from constant (which implicitly is time 0) but writes the modified mesh to 0+dt (dt from the controlDict), for instance...

Forum: OpenFOAM Meshing & Mesh Conversion

June 2, 2006, 05:01

Replies: 29

[Commercial meshers] Converting meshes that includes interfaces

Views: 5,368

Posted By gschaider

Hi Anne! I assume that the

Hi Anne!

I assume that the inlet and the outlet patch are to be coupled.

Let's open the UserGuide at Page U-141 and look at the definition of the cyclic patch there. What it says in...

Forum: OpenFOAM Meshing & Mesh Conversion

June 1, 2006, 16:47

Replies: 29

[Commercial meshers] Converting meshes that includes interfaces

Views: 5,368

Posted By gschaider

Hi Anne! 3.49% seems to be

Hi Anne!

3.49% seems to be an awful lot. I can't be bothered to look at the sources now, but if I remember it corrrectly cyclic boundary conditiions in OF assume, that the boundaries are either...

Forum: OpenFOAM Meshing & Mesh Conversion

May 31, 2006, 08:45

Replies: 29

[Commercial meshers] Converting meshes that includes interfaces

Views: 5,368

Posted By gschaider

Hello Marcus! @1: If your

Hello Marcus!

@1:
If your "interface" (Gambit nomenclature) is one patch which "looks" at both sides simply change it's type in Gambit to "interior" and write the .msh. fluentMeshToFoam can...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 07:19.