Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: just-right

Forum: ANSYS

August 6, 2011, 20:35

Replies: 4

ICEM: Thin Wall problem

Views: 2,068

Posted By just-right

Yeah lines exist between the adjacent surfaces. ...

Yeah lines exist between the adjacent surfaces.

A good way to approach the problem is to use thin cuts and the ignore wall thickness option. Also I found slightly decreasing the edge criteria to...

Forum: ANSYS

June 17, 2011, 07:29

Replies: 4

ICEM: Thin Wall problem

Views: 2,068

Posted By just-right

I have been using the "define thin cuts" approach...

I have been using the "define thin cuts" approach with improvements. It resolves the small areas a lot better, however, I still encounter various difficulties. Primarily the area where the small...

Forum: ANSYS

June 16, 2011, 12:33

Replies: 4

ICEM: Thin Wall problem

Views: 2,068

Posted By just-right

I have seperated the large surfaces and the small...

I have seperated the large surfaces and the small surfaces. There seems great sensitivity to the edge criterion. However, even though the curves that define the edges as well as the points are still...

Forum: ANSYS

June 15, 2011, 13:39

Replies: 4

ICEM: Thin Wall problem

Views: 2,068

Posted By just-right

ICEM: Thin Wall problem

I am meshing a wing like shape in close proximity to the ground. The geometry is 2 mm thick with an endplate on the side.

I am having problems with patch dependent meshing in relation to the...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 11:58.