Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: Boris_M

Forum: FloEFD, FloWorks & FloTHERM

December 24, 2016, 05:00

Replies: 5

Solidworks Flow Simulation 2011: Thermal Modeling of light sources

Views: 7,871

Posted By Boris_M

Hi Ethan, try this, but it might need some...

Hi Ethan,

try this, but it might need some calibration with an experiment as the filament definition does as well.

1. Extract the inside volume of the fluorscent bulb as a fluid volume solid...

Forum: FloEFD, FloWorks & FloTHERM

May 22, 2012, 10:23

Replies: 5

Solidworks Flow Simulation 2011: Thermal Modeling of light sources

Views: 7,871

Posted By Boris_M

Hi Eric, Are you sure it only has 36,75W flux?...

Hi Eric,
Are you sure it only has 36,75W flux? That would be just 8% radiation?
I would rather use the constant temperature on the filament accoring to it's surface temperature which is usually...

Forum: FloEFD, FloWorks & FloTHERM

May 4, 2012, 15:53

Replies: 5

Solidworks Flow Simulation 2011: Thermal Modeling of light sources

Views: 7,871

Posted By Boris_M

Yes, I've worked with this quite some time and...

Yes, I've worked with this quite some time and received very good results compared to measurments.

In general there are two ways to define a light source. For LEDs you usually don't need any...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 02:07.