CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Members List Search Today's Posts Mark Forums Read

Showing results 1 to 8 of 8
Search took 0.00 seconds.
Search: Posts Made By: guilha
Forum: OpenFOAM Running, Solving & CFD February 15, 2014, 19:59
Replies: 91
Views: 56,621
Posted By guilha
It works with the simple decomposition method,...

It works with the simple decomposition method, however some probes are lost.
Forum: OpenFOAM Running, Solving & CFD February 15, 2014, 19:01
Replies: 91
Views: 56,621
Posted By guilha
These are the first lines of the decomposeParDict...

These are the first lines of the decomposeParDict

/*--------------------------------*- C++ -*----------------------------------*\
| ========= | ...
Forum: OpenFOAM Running, Solving & CFD February 15, 2014, 18:41
Replies: 91
Views: 56,621
Posted By guilha
In the previous post the checkMesh output was...

In the previous post the checkMesh output was shown without the decomposition, after decomposing there is an error

/*---------------------------------------------------------------------------*\...
Forum: OpenFOAM Running, Solving & CFD February 15, 2014, 18:37
Replies: 91
Views: 56,621
Posted By guilha
Bruno thanks a lot for your replies and all the...

Bruno thanks a lot for your replies and all the support.

Running the checkMesh in parallel gives an error yes

/*---------------------------------------------------------------------------*\
|...
Forum: OpenFOAM Running, Solving & CFD February 15, 2014, 17:32
Replies: 91
Views: 56,621
Posted By guilha
Good evening, I am again in this thread...

Good evening,

I am again in this thread because recently I have had a wierd error. When I run my case in 16 processors or 24 (the cases tested), no problems appear, however with more processors...
Forum: OpenFOAM Running, Solving & CFD October 14, 2013, 13:37
Replies: 91
Views: 56,621
Posted By guilha
Hello Bruno, thank you for your analysis. I have...

Hello Bruno, thank you for your analysis. I have been too much busy lately.

The test between the machines, I did not do because I can not use x processors of one machine and y processors of the...
Forum: OpenFOAM Running, Solving & CFD September 30, 2013, 11:02
Replies: 91
Views: 56,621
Posted By guilha
Hello Bruno and all other FOAMers, thanks for...

Hello Bruno and all other FOAMers, thanks for your help and patience

I did not have time to test the communication between the machines.

Now, following your list:

1 - Yes, I have cyclic...
Forum: OpenFOAM Running, Solving & CFD September 26, 2013, 15:11
Replies: 91
Views: 56,621
Posted By guilha
Some errors and doubts

I was running a compressible LES simulation when it stopped with a similar or the same error, displayed just below.


Mean and max Courant Numbers = 0.0327681 0.0831581
Time = 0.00128178
...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -4. The time now is 07:05.