Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: rvl565

Forum: FLUENT

July 29, 2013, 16:20

Replies: 11

Mesh interface generation

Views: 13,743

Posted By rvl565

Thanks for the answers!

Thanks for the answers!

Forum: FLUENT

July 26, 2013, 13:08

Replies: 11

Mesh interface generation

Views: 13,743

Posted By rvl565

Hi, Thanks for the reply, I checked and all...

Hi,

Thanks for the reply, I checked and all the walls seem to have e-6 areas where as the interfaces have e-2 areas, also the interface-interior zone has e-2 areas. So i guess i can move forward...

Forum: FLUENT

July 20, 2013, 13:34

Replies: 11

Mesh interface generation

Views: 13,743

Posted By rvl565

I have attached a picture of my current mesh. ...

I have attached a picture of my current mesh.

To get a conformal mesh at the interface i grouped the two parts together (form new part) and then meshed the geometry. However after doing this i can...

Forum: FLUENT

July 20, 2013, 13:33

Replies: 11

Mesh interface generation

Views: 13,743

Posted By rvl565

Forum: FLUENT

July 19, 2013, 12:52

Replies: 11

Mesh interface generation

Views: 13,743

Posted By rvl565

Thanks for the reply! However, i did make...

Thanks for the reply!

However, i did make sure that the two parts were a perfect fit. I made both the regions in separate files in solidworks and made sure that the geometries were fitting...

Forum: FLUENT

July 18, 2013, 18:31

Replies: 11

Mesh interface generation

Views: 13,743

Posted By rvl565

Mesh interface generation

Hi,

I am simulating flow in a centrifugal compressor with the casing using MRF.
In doing so, I have two regions a casing fluid region and an impeller fluid region ( non conformal mesh ).

Now...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 14:09.