Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: jackr84

Forum: ANSYS Meshing & Geometry

September 16, 2009, 02:44

Replies: 10

[GAMBIT] Modify geometry

Views: 1,947

Posted By jackr84

Hi, how do i send to you the file?

Hi, how do i send to you the file?

Forum: ANSYS Meshing & Geometry

September 15, 2009, 12:54

Replies: 10

[GAMBIT] Modify geometry

Views: 1,947

Posted By jackr84

I have a iges file,getted from a scanner 3d.can i...

I have a iges file,getted from a scanner 3d.can i modify the position of muffler?i would change the referiment system

Forum: ANSYS Meshing & Geometry

September 15, 2009, 12:26

Replies: 10

[GAMBIT] Modify geometry

Views: 1,947

Posted By jackr84

it is difficult because the geometry was...

it is difficult because the geometry was imported.Can i create planes to split volume in three parts?

Forum: ANSYS Meshing & Geometry

September 15, 2009, 08:16

Replies: 10

[GAMBIT] Modify geometry

Views: 1,947

Posted By jackr84

ah ok, I'll do this, thank you!!!!

ah ok, I'll do this, thank you!!!!

Forum: ANSYS Meshing & Geometry

September 15, 2009, 02:30

Replies: 10

[GAMBIT] Modify geometry

Views: 1,947

Posted By jackr84

I have a virtual geometry, therefore the command...

I have a virtual geometry, therefore the command is the same or it is another. Thank you.

Forum: ANSYS Meshing & Geometry

September 11, 2009, 14:46

Replies: 10

[GAMBIT] Modify geometry

Views: 1,947

Posted By jackr84

Modify geometry

Hi,I have a problem. I must divide a muffler (there is a photo) in three parts:
inlet;
porous media;
outlet;
What command should I use? I thinked to do a section with a plane throught doing some...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 00:31.