Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: rwryne

Forum: STAR-CCM+

June 26, 2012, 15:47

Replies: 11

Setting mass flow rate profile at an inlet

Views: 4,162

Posted By rwryne

Think you're almost there, but not quite. ...

Think you're almost there, but not quite.

You should be using position or centroid (not sure of difference, if any, for faces)

I think this will work:
...

Forum: STAR-CCM+

April 27, 2012, 08:32

Replies: 11

Setting mass flow rate profile at an inlet

Views: 4,162

Posted By rwryne

I do not think spherical would work. You will...

I do not think spherical would work. You will have to use cylindrical to get it right.

However, I think method two (using sqrt(x^2+y^2)) would be the best bet.

Forum: STAR-CCM+

April 26, 2012, 15:57

Replies: 11

Setting mass flow rate profile at an inlet

Views: 4,162

Posted By rwryne

Never done this, but I can see two ways: 1)...

Never done this, but I can see two ways:

1) set up a cylindrical coordinate system (Tools->Coordinate Systems)

---or----

2) Just use the relation that r = sqrt(x^2+y^2). your field...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 09:42.