Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: BrolY

Forum: ANSYS Meshing & Geometry

September 21, 2011, 04:44

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 8,998

Posted By BrolY

oh, you want to improve the quality of your mesh...

oh, you want to improve the quality of your mesh ??
In your 1st post, you asked how to create the same mesh than the one shown in the pictures ...
So, I guess you try to improve this mesh by...

Forum: ANSYS Meshing & Geometry

September 21, 2011, 03:54

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 8,998

Posted By BrolY

Ok here we go: 1) Create the 2 cuts as you...

Ok here we go:

1) Create the 2 cuts as you did before
2) Create an o-grid for all of them
3) Add another split in the o-grid
Your blocking should be like the one at the picture 1

4) Merge...

Forum: ANSYS Meshing & Geometry

September 20, 2011, 08:56

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 8,998

Posted By BrolY

I can't open solidwork file with my ICEM. So...

I can't open solidwork file with my ICEM.
So please send a .stl file ;)

Here is another tip :

1) show the VORFN part, and add the 3 blocks around the one where you want to create your Y block...

Forum: ANSYS Meshing & Geometry

September 20, 2011, 07:35

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 8,998

Posted By BrolY

You have to remove that block and use the...

You have to remove that block and use the vertices of the remaining blocks to create your 1/4 O-grid.

Post the geometry here, I will have a look and show you the steps to create that Y block ;)

Forum: ANSYS Meshing & Geometry

September 20, 2011, 05:41

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 8,998

Posted By BrolY

Before creating the Y block, you have to delete...

Before creating the Y block, you have to delete the previous one !

Another tip, once you have created your Y block, always go to Blocking -> Check Blocks -> Fix Inverted Block. Otherwise, you...

Forum: ANSYS Meshing & Geometry

September 19, 2011, 08:18

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 8,998

Posted By BrolY

Blocking -> Create Block -> From Vertices/faces ...

Blocking -> Create Block -> From Vertices/faces

Select 3D as Dimension, Hexa as Block Type and then Quarter O-Grid

Have fun ;)

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 07:20.