Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: vmeertens

Forum: ANSYS Meshing & Geometry

November 29, 2011, 09:15

Replies: 5

[ANSYS Meshing] Free surface in Workbench

Views: 2,925

Posted By vmeertens

Hi all, I’ve read some of the tutorials on...

Hi all,

I’ve read some of the tutorials on creating volumes in Design Modeler.

I have to do some research on the fluid around a hull. For this I want the mesh to be finer on the free surface....

Forum: ANSYS Meshing & Geometry

November 3, 2011, 04:09

Replies: 5

[ANSYS Meshing] Free surface in Workbench

Views: 2,925

Posted By vmeertens

Thanks a lot for your reply! I will try it...

Thanks a lot for your reply!

I will try it as soon as possible :)

Forum: ANSYS Meshing & Geometry

November 3, 2011, 02:35

Replies: 5

[ANSYS Meshing] Free surface in Workbench

Views: 2,925

Posted By vmeertens

Thx for your reply! I already have a...

Thx for your reply!

I already have a geometry, but I can't find the similar operation as "subtract" in Gambit.

Now I have the hull in a box, but I'm not sure what the next step should be.

Forum: ANSYS Meshing & Geometry

November 2, 2011, 10:10

Replies: 5

[ANSYS Meshing] Free surface in Workbench

Views: 2,925

Posted By vmeertens

Free surface in Workbench

Dear all,

I have started to work witch Ansys Workbench since last week. Before that I was used to Gambit, but as Gambit doesn’t support 64bit, I was forced to switch.

I have to simulate...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 19:51.