Forum: OpenFOAM Programming & Development
September 20, 2013, 10:44
|
Replies: 22
Views: 5,193
|
Forum: OpenFOAM Programming & Development
September 20, 2013, 10:15
|
Replies: 22
Views: 5,193
|
Forum: OpenFOAM Programming & Development
September 20, 2013, 09:46
|
Replies: 22
Views: 5,193
|
Forum: OpenFOAM Programming & Development
September 20, 2013, 09:16
|
Replies: 22
Views: 5,193
I'm afraid, but I don't think that I've well...
I'm afraid, but I don't think that I've well understood your answer.
I've well meshed the two blocks with only one cell, the results is in attached file.
Should I change the coordinates of the...
|
Forum: OpenFOAM Programming & Development
September 20, 2013, 08:02
|
Replies: 22
Views: 5,193
|
Forum: OpenFOAM Programming & Development
September 20, 2013, 06:22
|
Replies: 22
Views: 5,193
|
Forum: OpenFOAM Programming & Development
September 20, 2013, 06:21
|
Replies: 22
Views: 5,193
|
Forum: OpenFOAM Programming & Development
September 20, 2013, 05:28
|
Replies: 22
Views: 5,193
I've modified my file.
When I use in the...
I've modified my file.
When I use in the end of the blockMeshDict file the patches key word it works.
But when using the mergePatchPairs it doesn't work !
Could you please check the error for...
|
Forum: OpenFOAM Programming & Development
September 20, 2013, 04:49
|
Replies: 22
Views: 5,193
|
Forum: OpenFOAM Programming & Development
September 20, 2013, 04:10
|
Replies: 22
Views: 5,193
Dear Gerhard Holzinger,
Again thank you for...
Dear Gerhard Holzinger,
Again thank you for your useful informations.
I'll follow your suggestions to create two blocks and use the mergePatachesPairs.
I've only one question, I'll be very...
|
Forum: OpenFOAM Programming & Development
September 19, 2013, 12:51
|
Replies: 22
Views: 5,193
|
Forum: OpenFOAM Programming & Development
September 18, 2013, 09:20
|
Replies: 22
Views: 5,193
checkMesh
Dear Foamers,
I've a question regarding the checkMesh tool.
After creating my geomertry, It runs without any errors the blockMesh and I well presented my required geometry in ParaFoam. ...
|