Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: Artur

Forum: OpenFOAM Meshing & Mesh Conversion

September 23, 2013, 15:50

Replies: 14

[snappyHexMesh] bad trailing edge boundary layer with snappyHexMesh

Views: 6,455

Posted By Artur

I think it would be best to do this right after...

I think it would be best to do this right after the meshing process as having two BC's for the same patch might make the solver do some hard to predict thing, I imagine.

Forum: OpenFOAM Meshing & Mesh Conversion

September 22, 2013, 03:52

Replies: 14

[snappyHexMesh] bad trailing edge boundary layer with snappyHexMesh

Views: 6,455

Posted By Artur

Try removing the empty boundary condition, either...

Try removing the empty boundary condition, either by manually editing the boundary file or by running the following:
createPatch -overwrite
See if that helps with removing the error message...

Forum: OpenFOAM Meshing & Mesh Conversion

July 9, 2013, 05:20

Replies: 14

[snappyHexMesh] bad trailing edge boundary layer with snappyHexMesh

Views: 6,455

Posted By Artur

Like the previous poster, I ran across this old...

Like the previous poster, I ran across this old post and thought I'd post a reply as well.

I've found that replacing a sharp trailing edge feature with one with a small radius leads to a much...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 08:33.