Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Tanjina

Forum: ANSYS Meshing & Geometry

October 17, 2013, 14:16

Replies: 8

[ANSYS Meshing] Multiple line select for named selection

Views: 11,948

Posted By Tanjina

Dear Vidyanand and Jrunsten, Both of your...

Dear Vidyanand and Jrunsten,

Both of your advice I tried and both works ! Thank you guys.For my case Jrunsten's method was more applicable except a small problem. ( please check the attached...

Forum: ANSYS Meshing & Geometry

October 10, 2013, 10:28

Replies: 8

[ANSYS Meshing] Multiple line select for named selection

Views: 11,948

Posted By Tanjina

Now it's clear ! Please check the attachment....

Now it's clear !
Please check the attachment. I have to select --- line. If i select the edge, after using "extend the limit" it selects all the --- line. But I need - - - - ( line 1,3,5,7 or...

Forum: ANSYS Meshing & Geometry

October 10, 2013, 09:46

Replies: 8

[ANSYS Meshing] Multiple line select for named selection

Views: 11,948

Posted By Tanjina

Thank you jrusten for replying. I am working on...

Thank you jrusten for replying. I am working on workbench and solving in fluent.

I just googled about "extend to limits", and got more confused. Could you please elaborate a bit?

Forum: ANSYS Meshing & Geometry

October 10, 2013, 09:12

Replies: 8

[ANSYS Meshing] Multiple line select for named selection

Views: 11,948

Posted By Tanjina

Multiple line select for named selection

Hello Everyone.

I am searching for any way by which I can select multiple line easily. I have to make some model of 80m and there is 10 line per meter I have to select. I did the same for 60 m, 40...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 12:15.